32
2.2.2 Wall Mounted Installations
For wall mounted installations, use only the Access Point bracket and angle adjust bracket if required.
CAUTION
NOTE
NOTE
1. With the open slot connections facing down, attach the angle adjust bracket at the desired mounting
location using four #10/32 lag bolts.
2. Using a torque wrench or a ratchet and a 10mm socket, or an adjustable wrench, attach (but don't tighten)
the Access Point bracket to the AP-7562 with four M6 hex flange screws and insert two M6 hex flange
screws into the bottom holes on the sides of the Access Point bracket.
Always mount the AP-7562 with the black gore vent facing down.
The U-bolt and band clamps are not included in the mounting bracket kit.
The lag bolts are not included in the mounting bracket kit.
AP-7562 Access Point