Table of Contents
Advertisement
Install Steering Wheel
1.
Move front wheels straight ahead.
2.
Slide the steering wheel over shaft. Line up the
hole in the steering wheel with the hole in the
shaft (Fig. 3). From the seat you should be able
to read the brand logo on the steering wheel.
3.
To align the holes, insert a punch or long nail
partially through the holes in the steering wheel
and shaft. Then insert the roll pin into the hole
on the opposite side.
4.
Using a hammer, drive the roll pin in until it is
flush with the outside of the steering wheel
(Fig. 3).
Figure 3
1. Steering wheel
1
2
2. Roll pin
Install Seat
Note:
If the seat is already installed, proceed
to Activate The Battery, page 4.
1.
Insert seat switch wire cable through the hole in
the seat base (Fig. 4).
2.
Position the seat onto the seat base by inserting
the two shoulder bolts through key hole
openings at the end of both slots (Fig. 4).
3.
Thread the knob and flat washer through slot
into the rear center hole in the seat (Fig. 4).
Adjust the seat and tighten the knob.
4.
Push the seat switch connector fully into the
wire harness connector (Fig. 4).
5.
Secure the seat switch wire cable to seat base
with wire clip (Fig. 4).
Note:
Check seat switch wire routing, it must
not be pinched in seat brackets.
1
5
Figure 4
1. Seat
2. Wire and connector
3. Shoulder bolts
Set-Up Instructions
4
3
6
2
4. Knob and flat washer
5. Wire clip
6. Connectors
3
Advertisement
Table of Contents
