Install Steering Wheel; Install Seat - Toro Wheel Horse 8-25 Operator's Manual

Install Steering Wheel

1. Position wheels in straight ahead direction.
2. Slip spacer onto steering shaft until groove in
spacer fits over roll pin in shaft (Fig. 1).
3. Slip steering wheel over shaft and line the
steering wheel mount hole with the shaft
mounting hole (Fig. 1). Toro logo on steering
wheel insert should be readable from operator's
position.
1
Figure 1
1. Roll pin
2. Spacer
4. Insert a drift punch partially through the holes to
maintain alignment and insert the roll pin in
from the opposite side.
5. Drive the roll pin in until it is flush with the
outside of the wheel (Fig. 1).

Install Seat

1. Position seat onto seat base, inserting the seat
switch cable through the slot and aligning the
mounting holes (Fig. 2).
2. Slide wire clamp over seat switch wire (Fig. 2).
3. Using left front mounting slot in seat base,
loosely secure wire clamp and seat to seat base
with a capscrew and lock washer (Fig. 2).
2
2
3. Steering wheel insert
4. Mount seat to seat base with (3) remaining
capscrews and lock washers.
Figure 2
1. Seat base
2. Clamp
3. Capscrews and washers
Note: Seat may be adjusted for operator
comfort by positioning seat as desired
in seat base slots.
5. Tighten all locknuts.
6. Insert seat switch connector into wire harness
connector.
Assembly
4. Connector
5. Seat prop latch
13