Install Traction Control Rods
1.
Locate index tab on left and right rods vertical
and slide into control block (Fig. 1).
2.
Position (3) 1/2" (13 mm) spring washers onto
threaded end of rod, alternating as shown
(Fig. 1). Secure with 1/2" locknut.
Figure 1
1. Control rod
2. Index tab
m–3049
3. Spring Washer 1/2"
(13mm)
4. Locknut 1/2–13
Install Seat
1.
Tip seat pan up, place stop wire through hole and
align seat with adjustment slots (Fig. 2).
2.
Secure with (4) 5/16 x 3/4" (19 mm) bolts, 5/16"
washers and 5/16" spacers (Fig. 2).
3.
Slide seat to a convenient location and tighten
mounting bolts securely.
4.
Route stop switch wire through hole and press
connector into wire harness connector (Fig. 2).
m–3093
Figure 2
1. Seat
2. Seat pan
3. Bolt 5/16–18 x 3/4"
(19mm)
Assembly
4. Washer 5/16"
5. Spacer 5/16"
6. Stop switch connector
9