Omron HOME SECURITY SYSTEM - MOTION SENSOR FQM1-CM001 Operation Manual page 259

Connecting the CX-Programmer
Connecting through the USB port with a USB-Serial Conversion Cable
Connecting to the Peripheral Port
Cable
Using a CS1W-CN226/626
Cable
Using an RS-232C Cable
(XW2Z-200S-CV, XW2Z-
500S-CV, XW2Z-200S-V, or
XW2Z-500S-V)
236
USB type A plug, male
CS1W-CIF31
D-sub Connector
(9-pin male)
D-sub Connector
(9-pin female)
Recommended cable:
CS1W-CN226/626
USB type A plug, male
CS1W-CIF31
D-sub Connector
(9-pin male)
D-sub Connector
(9-pin female)
XW2Z-200S-CV, XW2Z-500S-CV,
XW2Z-200S-V, or XW2Z-500S-V
(See note.)
Note The connection must be a Host Link connection.
Connection Diagram
CS/CJ-series peripheral connector
Peripheral port
CS1W-CN118
D-sub Connector Peripheral port
(9-pin male)
D-sub Connector
(9-pin female)
Section 8-2