I Hear Distortion When Using The Aux Input - Denon HEOS 3 HS2 Owner's Manual

Contents

I hear distortion when using the AUX input

The analog output signals from some sources can be fairly strong. If the input level of the source device is turned up high, it
0
could overload the inputs of the HEOS device. This is unlikely to cause damage, but can cause distorted sound. Initially, set the
volume of the source to a medium – low level, then turn it up as needed. If you hear distortion, turn down the device's volume
control.
Connecting to a WPS network
If your wireless router support WPS (Wi-Fi Protected Setup™) your HEOS wireless speaker can optionally connect to your
network using the "Push Button" method by following these steps:
1. Press the WPS button on your router.
2. Within 2 minutes, press and hold the Connect button on the rear panel of the HEOS speaker for 3 seconds.
3. The LED on the front of the speaker will flash green for several seconds as it connects to your WPS router.
4. When the connection is complete, the LED on the front of the speaker will turn solid blue.
Setup Use
Solution
Solution
Troubleshooting
56
Status LED Appendix
Refer to Page
Refer to Page
－
7