I Hear Distortion When Using The Aux Input - Denon HOME 150 NV Owner's Manual

Contents
I hear a delay when using the AUX input with my TV
If you are connecting the AUX input with your cable or satellite box for enjoying TV audio through multiple speakers, you may hear a delay between
0
when you see someone speak and when you hear the audio. This is because the HEOS system must buffer the audio before it sends it out to the
speakers so that it arrives at all speakers at the same time. (v p. 22)
You can avoid this delay by listening only to the speaker which is directly connected to the set top box.
0
Connecting to a network using an iOS device
This speaker supports Apple's "WAC (Wireless Accessory Configuration)" setup mode. WAC setup mode allows you to connect your speaker to your
0
network without requiring you to type in the network name and password.
The iOS device firmware version needs to support iOS 10.0.2 or later.
1. Press and hold - and 13 buttons for 3 seconds.
2. Go to the Wi-Fi menu under Settings on your iOS device.
3. Select "Denon Home 150 NV" under "SET UP NEW AIRPLAY SPEAKER..." at the bottom of the list.
4. Select the network you want your speaker to connect to and select "Next".
5. Follow the instructions on the screen to complete setup.
HEOS system will stay in WAC setup mode for 15 minutes. If the device is not setup within 15 minutes, it will revert back to its previous network
connection. Press the 13 button if you want to cancel WAC setup mode.
The status LED will quickly blink 5 times.

I hear distortion when using the AUX input

The analog output signals from some sources can be fairly strong. If the input level of the source device is turned up high, it could overload the inputs of
0
the speaker. This is unlikely to cause damage, but can cause distorted sound. Initially, set the volume of the source to a medium – low level, then turn it
up as needed. If you hear distortion, turn down the device's volume control.
Setup Playback Troubleshooting
34
Status LED Appendix