Removing Water Tank; Refitting Water Tank - Fisher & Paykel RF201A Service Manual

819091D
12.4.8

Removing Water Tank

•
Turn the water off at source.
•
Remove all shelves.
•
Remove the PC duct cover and PC Sensor from duct cover
•
Unclip the water reservoir cover from the cabinet liner.
•
The reservoir is removed by sliding a flat bladed plastic putty knife or spatula on top of the tank, and
with a folding motion of the spatula, lever the tank lip from the LH side to the RH side until clip is lifted
from liner and the tank is removed.
Diagram A
•
Remove water tubes from tank.
12.4.9

Refitting Water Tank

•
Place the bottom section of the tank onto protrusion on PC liner (Refer Diagram C and D)
Diagram C
•
Push the tank towards the rear of the liner until top lip is clipped into position.
•
Refit cover (as per Diagram E).
Diagram A – tank in position
Diagram B Fit spatula on the
RH side of lip and move to RH
side until unclipped.
Hoses are accessible once tank is removed.
54
Diagram B
Diagram D