Fisher & Paykel RF201A Service Manual page 38

819091D
Fault Code 26
Reason:
Primary Action:
Secondary Action:
Fault Code 27
Reason:
Primary Action:
Secondary Action:
Fault Code 28
Reason:
Primary Action:
Secondary Action:
Fault Code 29
Reason:
Primary Action:
Secondary Action:
Fault Code 32
Reason:
Primary Action:
Fault Code 33
Reason:
Primary Action:
Fault Code 34
Reason:
Primary Action:
Fault Code 40
Reason:
Primary Action:
Fault Code 41
Reason:
Primary Action:
Icemaker motor timed out
The icemaker gearbox is not returning to the start position and ends signal to
controller.
Check the gearbox, and if faulty, replace.
Icemaker motor current high.
Check motor for obstruction. Check wiring at both the icemaker gearbox and the
power module.
Clear obstruction. Test motor operations. Check the gearbox motor resistance. If
not within limits, replace motor.
Icemaker solenoid current high.
Check the connections to the solenoid. Check the resistance of the solenoid.
Correct loose connections. Replace the solenoid if faulty.
Icemaker solenoid current low.
Check the connection to the solenoid. Check the resistance of the solenoid.
Correct loose connections at the module or the water valve. Replace the solenoids if
open circuit.
Solenoid driver 1 has failed. If this happens the water dispenser will still be
operating, however, as Solenoid Driver 1 has failed the product has reverted to
Solenoid Driver 2 to dispense water. Fault code 32 will be displayed to make the
customer aware of the fault.
Check the solenoid resistance. If not within limits, replace the solenoid. If OK,
replace the display module if the problem still present.
Solenoid driver 2 has failed. The module has detected a fault with Solenoid Driver 2;
however, Solenoid Driver 1 may still be operational and the water dispenser is still
working.
Check the solenoid resistance. If not within limits, replace the solenoid. If OK,
replace the display module.
Both Solenoid Drivers 1 and 2 have been detected to have a fault.
Check the solenoid resistance. If not within limits, replace the solenoid. If OK,
replace the display module.
Icemaker solenoid Transistor 1 Short Circuit. A transistor on the controller that
drives the icemaker solenoid has failed. This could be as a result of a fault in the
solenoid.
Check the solenoid resistance. If not within limits, replace the solenoid. Check the
wiring and connections at the solenoid and the module. If OK, replace the control
module.
Icemaker solenoid transistor 2 Short Circuit.
Check the solenoid resistance. If not within limits, replace the solenoid. Check the
wiring and connections at the solenoid and the module. If OK, replace the control
module.
38