Strobe Light Level Adjustment - Sony Handycam DCR-PC115 Service Manual

DCR-PC115/PC115E/PC120BT/PC120E

16. Strobe Light Level Adjustment

Adjust the light level when the strobe light flashes.
Subject
Adjustment Page
Adjustment Address
Note 1: Background paper (J-2501-130-A). Perform this adjustment in the
dark room or use a dark box.
Note 2: Any light other than the strobe light should not light up the plate.
Note 3: This adjustment should be carried out upon completion of "HALL
Adjustment" and "Flange Back Adjustment".
Note 4: Check that the data of page: 6, address: 02 is "00". If not, to page:
6, address: 01, set data: 00, and press the PAUSE button.
Switch setting:
1) POWER .................................................................. CAMERA
2) FLASH ......................................................................... OPEN
(Press FLASH ( ) button and set to the forced flash mode
( ), and press PHOTO button.)
3) NIGHT SHOT .................................................................. OFF
Adjusting method:
Order Page Address Data
1 0 01
2 D F4
3 D F4
4 6 01
5
6 6 02
7 6 B8
Note 5: The adjustment data will be automatically input to page: F, address:
76, 77.
Processing after Completing Adjustments:
Order Page Address Data
1 6 01
2 6 02
3 D F4
4 D F4
5 0 01
RadarW RadarW RadarW RadarW RadarW
Paper which reflection rate is 18%
(1.0m from the front of the lens)(Note 1)
F
76, 77
Procedure
01 Set the data.
Write down the data.
04 Set the data, and press PAUSE button.
67 Set the data, and press PAUSE button.
Check the flashing.
Check that the data is "01".
(Note 5)
Check that the data is "00".
Procedure
00 Set the data, and press PAUSE
button.
00 Set the data.
Set the data which is written
down at step 2 of "Adjusting
method".
Press PAUSE button.
00 Set the data.
5-32