Strobe White Balance Adjustment & Check - Sony Handycam DCR-PC115 Service Manual

17. Strobe White Balance Adjustment & Check
Adjust and check the white balance when the strobe light flashes.
Subject Paper which reflection rate is 18%
(1.0m from the front of the lens)(Note 1)
Adjustment Page F
Adjustment Address 2E, 2F
Specified Value FA to FF or 00 to 06
Note 1: Background paper (J-2501-130-A). Perform this adjustment in the
dark room or use a dark box.
Note 2: Any light other than the strobe light should not light up the plate.
Note 3: This adjustment should be carried out upon completion of "HALL
Adjustment", "Flange Back Adjustment", "Auto White Balance
& LV Standard Data Input", "Auto White Balance Adjustment"
and "Strobe Light Level Adjustment".
Note 4: Check that the data of page: 6, address: 02 is "00". If not, to page:
6, address: 01, set data: 00, and press the PAUSE button.
Note 5: After the power is turned on, this adjustment can be done only
once.
Note 6: Displayed data of page 1 of the adjustment remote commander.
1 : XX : XX
Switch setting:
1) POWER .................................................................. CAMERA
2) FLASH ......................................................................... OPEN
(Press FLASH ( ) button and set to the forced flash mode
( ), and press PHOTO button.)
3) NIGHT SHOT .................................................................. OFF
RadarW RadarW RadarW RadarW RadarW
B-Y data
R-Y data
DCR-PC115/PC115E/PC120BT/PC120E
Adjusting method:
Order Page Address Data
1 0 01
2 D F4
3 D F4
4 6 01
5
6 6 02
7 6 02
8 6 01
9
10 6 02
11 6 04
12 1
Note7: The adjustment data will be automatically input to page: F, address:
2E, 2F.
Processing after Completing Adjustments:
Order Page Address Data
1 6 01
2 6 02
3 6 04
4 D F4
5 D F4
6 0 01
5-33
Procedure
01 Set the data.
Write down the data.
04 Set the data, and press PAUSE button.
B9 Set the data, and press PAUSE button.
Check the flashing.
Check that the data is "01".
(Note7)
00 Set the data.
E7 Set the data, and press PAUSE button.
Check the flashing.
Check that the data is "01".
29 Set the data.
Check that the R-Y data and B-
Y data (Note 6) satisfy the
specified value.
Procedure
00 Set the data, and press PAUSE
button.
00 Set the data.
00 Set the data.
Set the data which is written
down at step 2 of "Adjusting
method".
Press PAUSE button.
00 Set the data.