Using A Scsi Cable - Panasonic KX-P8410 Operating Instructions Manual

Using a SCSI Cable

Note for Terminator setting:
B The printer must be the last device in the chain. The terminator setting of all
other devices in the chain must be off.
Make sure the computer, printer and the other connected
1
peripheral devices are turned off.
2
Connect the SCSI cable to the computer's SCSI connector and
the printer's SCSI connector.
BA SCSI-2 board must be installed in the computer.
If you do not have a SCSI-2 board or a SCSI interface cable, you will need to
purchase one from your local computer store or dealer
Interface" specifications).
Computer's SCSI
interface connector
3
Make sure the SCSI ID No. of the printer is 1 (default setting).
BIf you have other devices connected to the computer, make sure that each
SCSI device has a different ID No.
BTo change the printer's ID No., use the ID No. switches (#1, #2, #3) located
on the back of the printer. Also refer to Table 1 on
Setup
( P. 15, 162 "SCSI
page 37.
35