Customer Service - Peg-Perego Polaris Ranger RZR Use And Care Manual

IF THE VEHICLE DOES NOT OPERATE?
• When operating in overload conditions, such as running the vehicle against a fixed object, through soft deep sand
or mud, or over rough uneven terrain, the overload circuit breaker will automatically disconnect the power. After
10 or more seconds,the circuit breaker will automatically reset, however-you must eliminate overload conditions
to resume normal driving.
• Check that all the plugs are properly connected.
• Check electrical switches. Replace if necessary.
• Check that the battery is connected to the electrical system.
IF THERE IS NO POWER?
• Fully recharge the batteries. If the problem persists, check with an Authorized PEG PEREGO Service Center.
For your convience, PEG PEREGO offers after-sales services, directly or through a network of
authorized service centers for repairs or replacement parts.
If you have any questions about your Peg Perego vehicle, please call our toll-free service lines at
1-800-728-2108 between 8 AM and 6:30 PM (EST) Monday through Friday. Trained customer
service representatives are available to take your call in English or Spanish.
In reference to the radio:
PROBLEMS?

CUSTOMER SERVICE

FCC STATEMENT (United States Only)
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules.
These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for
help.
Note: Changes or modifications not expressly approved by the
manufacturer responsible for compliance could void the user's
authority to operate the equipment.