Headlamp High/Low-Beam Changer; Flash-To-Pass; Windshield Wipers - Chevrolet 2010 Express Owner's Manual

Headlamp High/Low-Beam Changer

2 3 (Headlamp High/Low-Beam Changer): Pull the
turn signal lever all the way toward you to change the
headlamps from low to high beam. Then release it.
This instrument panel cluster light comes on when the
high beam headlamps are on.

Flash-to-Pass

This feature is used to signal to the vehicle ahead that
you want to pass.
If the headlamps are off or in the low-beam position,
pull the turn signal lever toward you to momentarily
switch to high-beams.
Release the lever to turn the high-beam headlamps off.

Windshield Wipers

The windshield wiper control is located on the
multifunction lever on the left side of the steering wheel.
N
Turn the band with on it to select the wiper speed.
8 (Mist): Single wipe, hold the band on
release. For several wipes, hold the band on
6
(Adjustable Interval Wipes): Turn the band to adjust
the delay time between wipes. Turn the band up for more
frequent wipes or down for less frequent wipes.
d (Low Speed): Slow wipes.
a
(High Speed): Fast wipes.
9 (Off): Turns the windshield wipers off.
When driving during the day and the wipers are
activated, the head lamps automatically turn on after
completing eight wipe cycles.
Clear ice and snow from the wiper blades before using
them. If frozen to the windshield, carefully loosen or
thaw them. Damaged blades should be replaced.
z
, then
z
longer.
4-5