Installing Batteries - Olympus DS DS-3400 Instructions Manual

Installing Batteries

This recorder can be used with AAA Alkaline
Batteries.
1
Lightly press down on the battery cover
release button, then open the battery
cover.
1
2
Insert two AAA batteries, observing the
correct polarity as shown in the
illustration below, then close the battery
cover.
Insert the batteries in the direction inscribed on
the inside of the recorder's battery compartment.
In addition, when inserting the batteries, insert
them so that the tape is under the batteries, as
shown in the illustration. The batteries can then
be removed easily by pulling up the tape. When
pulling on the tape the batteries may suddenly
pop out, so be sure to press down lightly on
the batteries with your finger while pulling.
12
Recharging Battery Pack
The battery indicator on the display changes
as the batteries lose power.
→
When appears on the display, replace the
batteries as soon as possible.
When the batteries are too weak, the recorder
shuts down and [
on the display.
Cautions Concerning the Battery
Warning
• Using batteries for which part or all
of the external coating (insulating
sheath) is peeling off or batteries
which have ruptured may cause fluid
leaks, overheating, and explosions.
For this reason such batteries should
absolutely not be used.
• Commercially available batteries for
which part or all of the external
coating (insulation sheath) has been
peeled off should absolutely not be
used.
Unusable batteries
Batteries for which the entire external coating
(insulating sheath) is peeled off (naked batteries),
or those where it has partially been peeled off.
→
Battery Low ] appears