Olympus EVOLT E-500 Advanced Manual page 173

Possible cause
The top left part of the picture appears too bright.
When shooting at slow
shutter speeds, noise may
be generated due to a rise
in temperature in the CCD
drive circuit.
Pictures cannot be played back on the monitor.
Pictures are not stored on
the card.
The card error occurs.
No picture is displayed on the TV when connected to the camera.
The video cable is not
connected correctly.
The camera's video output
signal is incorrect.
The TV 's video signal is
incorrect.
The monitor is hard to see.
The brightness is not
adjusted properly.
The monitor is exposed to
direct sunlight.
The computer does not recognize the camera correctly.
The camera's power is
turned off.
The USB driver was not
successfully installed.
The camera is in the
[CONTROL] mode.
Corrective action
Set [NOISE REDUCTION] to [ON] before taking
pictures.
"NO PICTURE" appears on the monitor. Record
pictures.
Refer to the error messages.
Connect the cable properly according to the
instructions.
Set the video signal according to the region
where used.
Set the TV to the video input mode.
Adjust the brightness of the monitor using the
menu.
Block the sunlight with your hand.
Set the power switch to ON.
Install the OLYMPUS Master.
Set [USB MODE] to [AUTO] or [STORAGE].
When [AUTO] is set, the selection screen for
USB connection is displayed every time you
connect the USB cable to the camera.
If you encounter problems
Ref. Page
P. 95
–
P. 168
P. 108
P. 135
–
P. 133
–
–
P. 155
P. 134
173
11