Grizzly G0783 Owner's Manual page 35

Adjusting Miter
Lock Lever
The miter lock lever (see Figure 42) ensures the
swiveling saw base remains locked at a desired
angle during the cut.
Lock lever adjustment components can be
accessed by removing the rear access panel or
through the front storage compartment.
Tools Needed:
Hex Wrench 6mm .............................................. 1
Wrench or Socket 14mm ................................... 1
Miter Lock Lever
Figure 42. Miter lock lever location
G0783 (Mfd. Since 05/15)
Qty
Vise Handwheel
To adjust lock lever:
1. DISCONNECT SAW FROM POWER!
2. Loosen cap screws securing lock lever arm to
lock bolt shown in Figure 43.
Lock
Bolt
Cap
Screw
(1 of 3)
Figure 43. Miter lock lever adjustment
components.
3.
Rotate lock lever left or right, as needed.
Re-tighten cap screws and tensioner hex
nuts, and then test lock lever range of move-
ment.
Note: Check lock lever clearance to ensure
it does not interfere with the vise handwheel
rotation when fully locked.
Tensioner
Hex Nut
(1 of 3)
Lock
Lever
Arm
-33-