Adjusting Miter Angle; Changing Blade - Grizzly G0783 Owner's Manual

Adjusting Miter
Angle
The head and column rotate 90° left or right of
center for precise angled cuts. The miter scale
shows the angle of the blade, and the miter lock
lever secures the angle for repeated cuts.
Ensure saw is properly mounted to floor before
performing cuts (see Page 15), as saw base can
shift with larger workpieces.
To set miter angle:
1. DISCONNECT SAW FROM POWER!
2. Release miter lock lever (shown in Figure 19).
Miter Lock Lever
Figure 19. Miter lock lever, column, and miter
scale location.
3.
Rotate saw headstock to desired angle using
miter scale as a guide. Once desired angle is
reached, move miter lock lever left to secure
setting.
4.
Ensure blade clearance by lowering saw
blade. If necessary, adjust vise jaw to provide
adequate clearance, as outlined in Adjusting
Vise on Page 19.
5.
Return saw to upright position.
-20-
Column
Miter Scale

Changing Blade

The Model G0783 uses an 11" saw blade designed
for cutting rectangular, square, and round metal
workpieces.
Metal cutting blades should be checked regular-
ly for wear or damage to ensure a high-quality
workpiece finish and to determine if replacement
is necessary.
Tools Needed:
Hex Wrench 8mm .............................................. 1
Retaining Ring Pliers ......................................... 1
The teeth of saw blades are
sharp and can easily cut
fingers and hands. Always
wear heavy leather gloves
when handling saw blades.
To replace blade:
1. DISCONNECT SAW FROM POWER!
2.
Disconnect blade guard linkage by removing
two cap screws connecting linkage to the
base of column neck (see Figure 20).
Linkage
Linkage Cap Screws
Figure 20. Removing guard linkage.
Qty
G0783 (Mfd. Since 05/15)