Table of Contents
Advertisement
3.
Remove temporary headstock plug (see
Page 16).
Temporary
Headstock
Plug
Figure 11. Removing temporary headstock plug.
4.
Thread lever arm several turns into headstock
until trigger button cord is on top of lever arm,
then use adjustable wrench to tighten hex nut
against headstock (see Figure 12).
5.
Connect trigger button cord to right side
of control box (see Figure 12) and tighten
knurled knob.
Trigger
Lever
Button
Arm
Cord
Oil Sight Glass
Figure 12. Lever arm and button cord installed.
-16-
6.
7.
Hex Nut
Thread lever cap onto lock lever (see
Figure 13).
Figure 13. Handle installed on lock lever.
Install blade (refer to Changing Blade on
Page 20 for blade installation).
G0783 (Mfd. Since 05/15)
Lever
Cap
Advertisement
Table of Contents
