Lubrication - Grizzly G0783 Owner's Manual

Vise Leadscrew
Lube Type ...Model T23962 or ISO 68 Equivalent
Lube Amount ........................................... Fill Cup
Lubrication Frequency ..............................Weekly
To lubricate vise leadscrew:
1. DISCONNECT MACHINE FROM POWER!
2.
Using vise handwheel, close vise jaws.
Vise Leadscrew
Figure 38. Oil cup leadscrew lubrication.
3.
Open each oil cup lid, and fill with ISO 68 or
equivalent oil, then move vise through its full
range of motion several times to disperse oil
along leadscrew.
4.
Wipe away any excess oil.
Note: For best performance, periodically
clean leadscrew thoroughly with mineral
spirits or other degreaser and then relubri-
cate.
G0783 (Mfd. Since 05/15)
Leadscrew
Oil Cup
(1 of 2)
Gearbox Oil
Lube Type ...Model T23962 or ISO 68 Equivalent
Lube Amount ............................................
Check/Add Frequency ..............................Weekly
Change Frequency ..................... Every 6 Months
Items Needed
Hex Wrench 8mm .............................................. 1
Open-End Wrench ⁄ " ....................................... 1
7
8
Drain Pan ........................................................... 1
Funnel ................................................................ 1
Additional Person .............................................. 1
To add/change gearbox oil:
1. DISCONNECT SAW FROM POWER!
2. Raise saw to upmost position, and remove
lever arm to access oil fill hole to allow oil to
drain more freely.
3.
Place oil drain pan beneath saw gearbox,
and remove oil drain plug, located on bottom
side of gearbox (see Figure 39).
Oil Fill Hole
Oil Drain Plug
Figure 39. Oil fill and drain plug locations.
4. Hold drain pan under drain plug, then tilt saw
gearbox forward, allowing oil to drain out.
5.
Have an assistant hold headstock in place,
and replace drain plug.
6.
Insert funnel into fill hole. Add approximately
⁄ -liter of ISO 68 or equivalent oil until oil level
1
2
is halfway in sight glass. Wait 10 seconds to
allow oil to settle in sight glass before taking
a reading.
7. Wipe away any excess oil and re-install lever
arm.
⁄ Liter
1
2
Qty
Sight Glass
-29-