Time Lapse Shooting - Olympus CAMEDIA C-70 ZOOM Advanced Manual

Time lapse shooting

Note
• Sequential shooting ([j], [i], [7]) is not possible in the following
situations.
When [R] is selected for the f mode, when [K] is set to [TIFF] or
when [NOISE REDUCTION] is set to [ON].
• High speed sequential shooting can only be used when [K] is set to [RAW].
• The flash does not fire during sequential shooting ([j], [i], [7]).
• In modes other than S and M, as the maximum shutter speed is set to 1/30
sec., adequate exposure is not obtained when shooting a dark subject.
• When auto bracketing in a mode other than S mode, the camera auto brackets
at a shutter speed of 1/30 sec. if the shutter speed is set longer than 1/30 sec.
with an exposure differential of 0.
• If the battery power is low and the battery check blinks during sequential
shooting, shooting stops and the camera starts saving the pictures you have
taken. Whether or not all of the shots are saved depends on how much battery
power remains.
• If there is not enough space available on the card for the number of frames you
have set during auto bracketing, you cannot continue shooting.
5
Time lapse shooting
This function lets you take a sequence of pictures automatically under
preset conditions. It is useful, for example, for taking pictures at specific
intervals of a flower opening. You are recommended to use a fully charged
battery or AC adapter when shooting over prolonged periods.
Mode dial
Top menu
1
Set the [PICTURES] and
[INTERVAL].
• ac : Selects the item or sets the
• bd
Setting range Number of pictures: 2 to 99
2
Press e.
72
[MODE MENU] [CAMERA]
number.
: Selects the column.
Interval: 1 min. to 60 min. in
1 min. increments
[TIMELAPSE] [ON] / [OFF]
g"Menus" (P.17)
TIMELAPSE
PICTURES
INTERVAL
SELECT SET
02
01 MIN
GO
OK