Olympus CAMEDIA C-70 ZOOM Advanced Manual page 158

Troubleshooting
Possible cause
The monitor does not turn on.
The camera is set to
[MONITOR OFF].
The viewfinder or monitor is hard to see.
There is condensation*
inside the camera.
The brightness of the
monitor is not adjusted
properly.
The monitor is exposed
to direct sunlight.
Vertical lines appear on
the monitor screen
during shooting.
The date recorded with the image data is wrong.
The date/time is not set.
The camera has been
left with the battery
removed.
The settings are returned to the factory default settings when the camera is turned
off.
[ALL RESET] is set to [ON]. Set [ALL RESET] to [OFF] in the mode menu.
The picture is out of focus.
The subject was too
close.
The subject is dark.
Auto focus is not
possible.
There is condensation*
10
on the lens.
158
Corrective action
Press e in the shooting mode to display the
top menu, then press c to select
[MONITOR ON].
Turn the camera off and wait until it dries
before turning it on again.
Select [s] in the mode menu and adjust the
brightness.
Block the sunlight with your hand or use the
viewfinder.
Aiming the camera at a bright subject in
sunlight may cause vertical lines to appear
on the screen. This is not a malfunction.
Set the date/time. The clock adjustment is
not factory-preset.
If the camera is left for 3 days with the battery
removed, the date/time setting is canceled.
Set the date/time again.
Move further away from the subject. To take
pictures closer than 8 cm (3.2") with the zoom
in the maximum WIDE position, use the
super macro mode.
Set [AF ILLUMINATOR] to [ON] in the mode
menu.
Use manual focus or focus lock to focus on
the subject and then shoot.
Turn the camera off and wait until it dries
before turning it on again.
Ref.
page
P.23
–
P.114
–
–
P.115
P.115
P.103
P.36
P.48
P.50,
24
–