Removing The Server From A Cabinet - Gateway E-9425R User Manual

www.gateway.com

Removing the server from a cabinet

Screws are required to support the front
and back of the server. You must support
the server while removing the front
screws and back screws. If the server is
not supported, damage to the server or
injury may result.
Attach the handles to the sides of the server with two mounting screws
2
on each side.
Remove the bezel lock keys from the inside of the bezel, then insert the
3
left side of the bezel into the left handle and swing the right side of the
bezel in until it snaps into place.
When the bezel is in place, lock the bezel by inserting the key into the lock
4
in the lower right corner of the bezel and turning it clockwise until it stops.
Put the key in a safe place.
5
To remove the server from a cabinet:
Warning
While supporting the server, remove the front and rear mounting screws
1
that hold the server in the cabinet.
Remove the server from the cabinet.
2
Mounting your server into a cabinet
17