Adjusting The Volume - Canon ZR 90 Instruction Manual

Adjusting the Volume
When you use the LCD screen for playback, the camcorder plays back the sound via
built-in speaker. The built-in speaker does not sound when you close the LCD panel.
-
J"" - " < ' 'I'
or'l'
CARD e'AMERA
i
~,;;
IX: \ i
~
+.-
CAMERA ,
MENU
I
VCR SETUP
I~I:
AV / PHONES (I •• AV
(OJ
39)
I .
Open the menu and select [VCR SETUP]. Select [AV/PHONES
0],
set it to
[PHONES
0]
and close the menu.
WhenU$ing . . HeadphQn.es
The headphones terminal also serves as AV terminal. Headphones can only be used
when
"0"
is displayed on the screen. If not, change the setting following the
procedure below.
. . . 0 The built~in speaker does not sound when
"0"
is displayed.
. . 0 Do not connect headphones unless
"0"
is displayed as it produces noise.
~djusti[1g.Jhe.vQ.I.LlI11
. . e
' * ..
t
J-: r '"
i~,.,?+.-X
1-1 "'" -
~':~ ~~~"~'!~ ~ :,~
Turn the SET dial up to increase the volume, and down
to lower the volume.
• A volume bar appears for 2 seconds.
• You can turn off the
volu~e
completely by turning the SET dial
down until [OFF] appears. Turn the SET dial up to increase the volume again.
35