Canon ZR 90 Instruction Manual page 132

List of Messages
Message
Explanation CD
SET THE TIME ZONE, You have not set the time zone, date and time. This message
21
DATE AND TIME appears each time you turn the power on until you set the
time zone, date and time.
CHANGE THE Battery pack is exhausted. Replace or charge the battery 13
BATIERY PACK pack.
TH E TAPE IS SET FOR Cassette is protected. Replace the cassette or change the
138
ERASURE PREVENTION position of the protect switch.
REMOVE THE Camcorder stopped operating to protect the tape. Unload 16
CASSETIE
and reload the cassette.
CHECK THE DV INPUT
DV cable is not connected, or the connected digital device is
80
turned off.
CONDENSATION HAS Condensation has been detected in the camcorder.
136
BEEN DETECTED
TAPE END
Tape reached the end. Rewind the tape or replace the
-
cassette.
CHECK THE CASSETIE You attempted to perform audio dubbing or AV insert on a 86
[REC MODE] tape recorded in a mode other than the SP mode.
88
CHECK THE CASSETIE You attempted to perform audio dubbing on a tape
88
[AUDIO MODE]
recorded in
16~bit
or 12-bit 4-channel sound.
CHECK THE CASSETIE You attempted to perform audio dubbing or AV insert on a 86
[BLANK]
tape with a blank section.
88
COPYRIGHT PROTECTED You attempted to play back a copyright protected tape. 83
PLAYBACK IS RESTRICTED
COPYRIGHT You attempted to dub a copyright protected tape. May also 83
PROTECTED DUBBING appear when an anomalous signal is received during analog
RESTRICTED
line-in recording, or during analog-digital conversion of a
copyright protected tape.
-
131