Xerox PHASER 3200MFP Service Manual page 7

Electric Shock and Fire Safety Precautions
Failure to follow the instructions could cause electric shock or potentially cause a fire.
1. Use only the correct voltage, failure to do so could damage the machine and potentially
cause a fire or electric shock.
2. Use only the power cable supplied with the machine. Use of an incorrectly specified cable
could cause the cable to overheat and potentially cause a fire.
3. Do not overload the power socket, this could lead to overheating of the cables inside the wall
and could lead to a fire.
4. Do not allow water or other liquids to spill into the machine, this can cause an electric shock.
Do not allow paper clips, pins or other foreign objects to fall into the machine. This could
cause a short circuit leading to an electric shock or fire hazard.
5. Never touch the plugs on either end of the power cable with wet hands. This can cause an
electric shock. When servicing the machine, remove the power plug from the wall socket.
6. Use caution when inserting or removing the power connector. The power connector must be
inserted completely, otherwise a poor contact could cause overheating and possibly leading
to a fire. When removing the power connector grip it firmly and pull.
7. Take care of the power cable. Do not allow it to be twisted, bent sharply round corners or oth-
erwise damaged. Do not place objects on top of the power cable. If the power cable is dam-
aged, it could overheat and cause a fire. Exposed cables can also cause an electric shock.
Replace a damaged power cable immediately, do not reuse or repair the damaged cable.
Some chemicals can corrode the insulator of the power cable. Weakening of the insulator or
exposing cables can cause fire and shock risks.
8. Ensure that the power sockets and plugs are not cracked or broken in any way. Any such
defects should be repaired immediately. Take care not to cut or damage the power cable or
plugs when moving the machine.
9. Use caution during thunder or lightning storms. Xerox recommends that this machine be dis-
connected from the power source when such weather conditions are expected. Do not touch
the machine or the power cord if it is still connected to the wall socket in these weather condi-
tions.
10. Avoid damp or dusty areas, install the machine in a clean and well ventilated location. Do not
position the machine near a humidifier. Damp and dust build up inside the machine can lead
to overheating and cause a fire.
11. Do not position the machine in direct sunlight. This will cause the temperature inside the
machine to rise and possibly lead to the machine failing to work properly and in extreme con-
ditions, could lead to a fire.
12. Do not insert any metal objects into the machine through the ventilator fan or other parts of
the casing, contact with a high voltage conductor could occur inside the machine and cause
an electric shock.
Phaser 3200MFP / Workcentre PE220 04/07
Introduction
v