Ups Connections; Terminal Block - 208/240; Out - Toshiba 1600XP SERIES Installation And Operation Manual

8. UPS Connections

8.1 Terminal Block - 208/240 V
The following illustration is a detail view of the terminal block and wiring connections used for 208/240
volt units (see "Appendix C: 1600XP/1600XPi Dimensions and Weights" on page C1).
1 2 3 4
G X1
L1 (L*) L2 (N*)
208/240 V
in
INPUT
* – If only one input line is hot, connect hot line to terminal 1 (L), and connect the Neutral line to terminal 2 (N).
NOTE 1 – If AC input power is 208 Vac rated, short terminals 11 and 12 with a jumper wire. DO NOT jumper terminal 13 to 12 or
11. Factory Setting is 208 Vac. Use the jumper wire provided by Toshiba. DO NOT add any additional jumpers.
NOTE 2 – If AC input power is 240 Vac rated, short terminals 12 and 13 with a jumper wire. DO NOT jumper terminal 11 to 12 or
13. Use the jumper wire provided by Toshiba. DO NOT add any additional jumpers.
NOTE 3 – EPO and Rmt Contacts function – See Section 8.2
1600XP/XPi Series Installation and Operation Manual – 60616-012
, 120/280/240 V
IN
Factory Installed N - G Jumper
5 6 7 8
X2 X3 G
N (0V)
32 V 88 V
120 V 120 V
208 V
240 V
OUTPUT

OUT

1,2
11 12 13 14
208 COM 240
EPO1 EPO2
208V 240V
NO
Jumper selection
See notes 1&2
EPO
15 16 17
REMOTE1 REMOTE2
NO
3 Rmt Contacts
3
11