Fisher & Paykel OB60SC5LC User Manual page 37

Refitting the side racks and catalytic panels
Fit the catalytic panel to the side rack
1 Ensure the panels are placed the correct way around:
the hole for the fixing screw goes to the front of the oven.
Note: The shiny side of the catalytic should face the
inside of the oven cavity.
2 Fit the rear prongs of the side rack through the
holes in the catalytic panel.
Replace the side rack
1 Slide the rear prongs of the side rack into the holes at the rear of the oven
2 Fit the side rack front tab (and catalytic panel if fitted) over the fixing screw.
3 Replace the fixing nut. You may use a coin to tighten the nut.
Rear prongs
CARE AND CLEANING
(some models only, purchased separately)
Catalytic panel
(if fitted)
Side rack
Fixing nut
35