Fisher & Paykel OB60SC5LC User Manual page 15

Fitting the side racks and catalytic panels
You will find your side racks in the accessory box
supplied with your oven. Catalytic panels may be
purchased separately.
Fit the catalytic panel to the side rack
1 Ensure the panels are placed the correct way around:
in models with side lights: the cutout fits over the
light and the hole for the fixing screw goes to the
front of the oven.
in models with a ceiling light: the hole for the fixing
screw goes to the front of the oven.
(Note: panels should sit flush against the oven wall).
2 Fit the rear prongs of the side rack through the
holes in the catalytic panel.
Fit the side racks
1 Slide the rear prongs of the side rack into the holes at the rear of the oven
2 Fit the side rack front tab (and catalytic panel if fitted) over the fixing screw.
3 Replace the fixing nut. You may use a coin to tighten the nut.
Rear prongs
INTRODUCTION
(purchased separately)
Catalytic panel
(if fitted)
Side rack
Fixing nut
13