Oki C9500 Maintenance Manual page 36

[OHP Sensor Replacement]
(7) Figure 2-3-13-1 shows the bottom of the multipurpose tray 4. First remove the cover 9 (figure
2-3-13-1). The cover 9 with five protrusions can be disengaged by removing them with a
screwdriver etc.
(8) Remove the OHP sensor 0 (figure 2-3-13-1). Only the sensor, which has the shape shown in
figure 2-3-13-2, can be detached by pushing those claws on its both sides which are shaded in
the figure, using a flatblade screwdriver etc. Be careful not to allow the cable attached to the
sensor to be broken.
Note! When cleaning the OHP sensor, wipe dirt such as paper powder off its sensing surface
that is as shown in figure 2-3-13-3, with a soft cloth or the tip of a brush. The shaded
areas, which are lenses, should be wiped especially carefully, taking care not to allow it
to be scratched.
41956001TH Rev.6
4
0
9
Figure 2-3-13-1 Bottom of Multipurpose Tray
Figure 2-3-13-2 OHP Sensor Composition
Figure 2-3-13-3 Top of OHP Sensor
Protrusion (at five places)
0
0
Oki Data CONFIDENTIAL
36 /