Oki C9500 Maintenance Manual page 128

6
Poor Fusing (Ink spreads or peels when touched with fingers)
• Is regulated paper being used?
NO Use regulated paper.
• YES Is the contact of the fuser unit connected properly?
NO Connect the contact of the fuser unit properly.
• YES Is the roller in the fuser unit dirty?
YES Replace the fuser unit assembly.
• NO Is the PAPER THICKNESS (menu 1) selected correctly?
Light: 64 g/m
Medium Heavy: 91 to 104 g/m
NO Set [Paper Thickness] properly.
• YES Is AC voltage output between CN connector pins 1 and 3 in the low-voltage power unit?
NO Replace the low-voltage power unit.
• YES Is the heat roller thermister resistance within the regulated value? (See Fig. 5-1)
(Approx. 190k-980kΩ in room temperature of 0-43 degrees Celsius.)
NO Replace the fuser unit.
• YES Is the back-up roller thermister resistance within the regulated value? (See Fig. 5-1)
(Approx. 190k-980kΩ in room temperature of 0-43 degrees Celsius.)
NO Replace the fuser unit.
• YES Does the fuser temperature match the set temperature?
Check the fuser temperature in the LCD display of the engine maintenance mode.
Heat roller (upper)
Back-up (lower) : 125-135 degrees (48H-53H)
NO Replace the fuser unit assembly.
• YES Replace the fuser unit assembly.
Note: 1. Remove EEPROM from the old board and set it on the new board upon replacing the
engine board (K7N PWB).
2. If EEPROM is not replaced, refer to section 3.2.2.
41956001TH Rev.6
2
Medium Light: 64 to 74 g/m
2
Heavy: 105 to 120 g/m
: 145-155 degrees (5FH-6BH)
2 2
Medium: 75 to 90 g/m
2
Ultra Heavy 121 to 203 g/m
Oki Data CONFIDENTIAL
2
OHP
128 /