Table of Contents
Advertisement
10.
Grip the piston shaft with soft jaws 727-02.
Fit the O-ring on the adjustment needle.
Apply plenty of red grease on the O-ring so
that the needle slides easily into the piston
shaft.
11.
Check the X-ring and O-ring on the seal
head. Replace if necessary. Smear plenty
of white grease on the X-ring before you fit
it. Use tool 0715-01 to get the X-ring into
the right position.
10.
Wrap some teflon tape arond the thread
of the shaft to protect the seal and O-ring
from damages. Apply some red grease
(146-01) to the tape and the shaft end.
Mount the seal head and the O-ring.
11.
Use a brass wire brush to clean the piston
rod from tape. Mount Spacer, Sleeve, Top-
out spring and the Piston holder.
12.
Tighten the Piston holder to a torque of 15
Nm.
13.
Refit the Compression/Rebound valve. Use
the picture below to make it right. Tighten
the 8 mm nut with a torque of 7 Nm.
14
10
10
12
15 Nm
11
X-ring
O-ring
Tool 0715-01
11
Piston holder
Topout spring
Sleeve
Spacer
13
8 mm Nut (7 Nm)
Advertisement
Table of Contents
