Table of Contents
Advertisement
Basevalve RIGHT side (rebound leg)
Basevalve LEFT side (compression leg)
7.
Apply some front fork oil (1311-01) to the
inner tube surface and carefully mount the
outer tube (slide it completely down).
WARNING!
!
Be careful not to damage the fork seal!
8.
Fill up with Öhlins front fork oil (1311-01) all
the way to the edge of the reservoir. Con-
tinue to fill until the oil level is the same in
both the reservoir and in the cylinder tube.
9.
Push the gas piston, with teflon band
and O-ring fitted, to the reservoir bottom
without allowing it to be pressed back over
the circlip groove, make sure that there is
no air between the piston and the oil. Use
tool 720-02.
Close the compression adjuster.
7
9
Tool 720-02
8
13
Advertisement
Table of Contents
