Linksys LAPN300 User Manual page 46

Allowed VLAN Enter the list of VLANs accepted by the WDS Root.
List
When VLAN is enabled, WDS Root receives from WDS
Stations only packets in the VLAN list. Packets not in the list
will be dropped.
The VLAN list is only applicable when VLAN is enabled.
The VLAN list includes 1 to 16 VLAN IDs separated by ","
such as "100,200,300,400,500,600,700,800".
Security Setting can be Disabled, WPA-Personal, WPA2-Personal,
Settings WPA2-Enterprise or WPA/WPA2-Enterprise.
WDS Station
Interface Enable or disable the WDS Station.
Status
Before configuring a WDS Station, be sure the following
settings of the device are identical to the WDS Root that will
be connected.
Workgroup Bridge and WDS will not work at the same time.
When Workgroup Bridge is enabled, WDS will be disabled
automatically.
Remote SSID Enter the name of the Root's SSID. Click Site Survey button
and choose from the list. You must do this for WDS Station
to connect to a remote WDS Root.
• IEEE 802.11 Mode
• Channel Bandwidth
• Channel (Auto is not recommended)
Note: To change IEEE 802.11 Mode and Channel
settings, go to Wireless  Basic Settings.
To change Channel Bandwidth setting, go to
Wireless  Advanced Settings.
Note: It is highly recommended that static channel is
configured on both APs. Do not use Auto channel
option when you enable WDS, as both APs in a WDS
link must be on the same radio channel. If Auto option
is configured, there is chance two access points run
on different channels and WDS link cannot establish.
46