Table of Contents
Advertisement
WDS screen
Spanning Tree (Recommended if you configure WDS connections)
Spanning Tree
When enabled, STP helps prevent switching loops.
WDS Root
Interface
Enable or Disable the WDS Root.
Status
Be sure the following settings on WDS Root device are
determined and configured. The WDS Station must use the
same settings as Root afterwards.
Workgroup Bridge and WDS will not work at the same time.
When Workgroup Bridge is enabled, WDS will be disabled
automatically.
Local SSID
Enter name of the WDS Root SSID (used when connected by
WDS Stations).
Local MAC
MAC address of the WDS Root SSID.
Address
Local Channel
The channel used by WDS Root SSID. WDS stations must
use same channel as the WDS Root.
Channel can be changed in "Basic Settings" page.
IEEE 802.11 Mode
•
•
Channel Bandwidth
•
Channel (Auto is not recommended)
Note: To change IEEE 802.11 Mode and Channel
settings, go to Wireless Basic Settings.
To change Channel Bandwidth setting, go to
Wireless Advanced Settings.
Note: It is highly recommended that static channel is
configured on both APs. Do not use Auto channel
option when you enable WDS, as both APs in a WDS
link must be on the same radio channel. If Auto option
is configured, there is chance two access points run
on different channels and WDS link cannot establish.
45
Hide quick links:
Advertisement
Table of Contents
