Linksys LAPN300 User Manual page 21

SNMPv3 Settings
SNMPv3 Settings
Access Control
Access Control
SNMP Trap
Trap Community
Trap Destination
Configure the SNMPv3 settings if you want to use
SNMPv3.
Username: Enter the username. It includes 0 to 32
characters. Special characters are allowed.
Authentication Protocol: None or HMAC-MD5.
Authentication Key: 8 to 32 characters. Special
characters are allowed.
Privacy Protocol: None or CBC-DES.
Privacy Key: 8 to 32 characters. Special characters are
allowed.
When SNMP is enabled, any IP address can connect to
the access point's admin page through SNMP. You can
enable access control to allow specified IP addresses.
Two IPv4 and two IPv6 addresses can be specified.
Enter the Trap Community server. It includes 1 to 32
characters. Special characters are allowed.
Two Trap Community servers are supported: can be
IPv4 or IPv6.
21