Table of Contents
Advertisement
Operation
Starting up the projector
1.
Plug the power cord into the projector
and into a wall socket. Turn on the wall
socket switch (where fitted). Check that
the POWER indicator light on the
projector lights orange after power has
been applied.
Please use the original accessories (e.g. power
cable) only with the device to avoid possible
dangers such as electric shock and fire.
2.
Press POWER on the projector
the projector and a start up tone sounds. The POWER indicator
light flashes green and stays green when the projector is on.
The start up procedure takes about 30 seconds. In the later stage of
start up, a startup logo is projected.
(If necessary) Rotate the focus ring to adjust the image clearness.
To turn off the ring tone, see
page 48
for details.
If the projector is still hot from previous activity, it will run the cooling fan for
approximately 90 seconds before energizing the lamp.
3.
To use the OSD menus, please set
them to your familiar language first.
4.
If you are prompted for a password,
press the arrow keys to enter a five
digit password. See
password function" on page 32
details.
5.
Switch all of the connected equipment on.
6.
The projector will start to search for input signals. The current input
signal being scanned displays in the upper left corner of the screen. If the
projector doesn't detect a valid signal, the message 'No Signal' will
continue displaying until an input signal is found.
You can also press SOURCE on the projector or remote control to
select your desired input signal. See
for details.
If the frequency/resolution of the input signal exceeds the projector's
operating range, you will see the message 'Out of Range' displayed on a
blank screen. Please change to an input signal which is compatible with the
28
Operation
"Turning off the Power on/off ring tone" on
"Utilizing the
for
"Switching input signal" on page 35
or remote control
Please select language
Press Enter to confirm, Exit to leave
to start
Advertisement
Table of Contents
