Table of Contents
Advertisement
3D Color Management
In most installation situations, color management will not be necessary, such
as in classroom, meeting room, or lounge room situations where lights
remain on, or where building external windows allow daylight into the room.
Only in permanent installations with controlled lighting levels such as
boardrooms, lecture theaters, or home theaters, should color management
be considered. Color management provides fine color control adjustment to
allow for more accurate color reproduction, should you require it.
Proper color management can only be achieved under controlled and
reproducible viewing conditions. You will need to use a colorimeter (color
light meter), and provide a set of suitable source images to measure color
reproduction. These tools are not provided with the projector, however,
your projector supplier should be able to provide you with suitable guidance,
or even an experienced professional installer.
The Color Management provides six sets (RGBCMY) of colors to be
adjusted. When you select each color, you can independently adjust its range
and saturation according to your preference.
If you have purchased a test disc which contains various color test patterns
and can be used to test the color presentation on monitors, TVs, projectors,
etc. You can project any image from the disc on the screen and enter the 3D
Color Management menu to make adjustments.
To adjust the settings:
1.
Go to the Picture menu and highlight 3D Color Management.
2.
Press MODE/ENTER and the 3D Color Management page displays.
3.
Highlight Primary color and press ◄/► to select a color from among
Red, Green, Blue, Cyan, Magenta and Yellow.
4.
Press ▼ to highlight Hue and press ◄/► to select its range. Increase in
the range will include colors consisted of more proportions of its two
adjacent colors.
Please refer to the illustration to the
right for how the colors relate to each
other.
For example, if you select Red and set
its range at 0, only pure red in the
projected picture will be selected.
Increasing its range will include red
close to yellow and red close to
magenta.
5.
Press ▼ to highlight Saturation and
adjust its values to your preference by
pressing ◄/►. Every adjustment made will reflect to the image
immediately.
42
Operation
Yellow
RED
Cyan
Magenta
BLUE
GREEN
Advertisement
Table of Contents
