Table of Contents
Advertisement
Replacing the remote control battery
1.
To open the battery cover, turn the remote control over to view its
back, push on the finger grip on the cover and slide it up in the direction
of the arrow as illustrated. The cover will slide off.
2.
Remove any existing batteries (if necessary) and install two AAA
batteries observing the battery polarities as indicated in the base of the
battery compartment. Positive (+) goes to positive and negative (-) goes
to negative.
3.
Refit the cover by aligning it with the base and sliding it back down into
position. Stop when it clicks into place.
• Avoid excessive heat and humidity.
• There may be battery damage if the battery is incorrectly replaced.
• Replace only with the same or equivalent type recommended by the
battery manufacturer.
• Dispose of the used battery according to the battery manufacturer's
instructions.
• Never throw a battery into a fire. There may be danger of an explosion.
• If the battery is dead or if you will not be using the remote control for a
long time, remove the battery to prevent damage to the remote control
from possible battery leakage.
Introduction
19
Advertisement
Table of Contents
