Table of Contents
Advertisement
Troubleshooting
The projector does not turn on.
Cause
There is no power from the
power cable.
Attempting to turn the projector
on again during the cooling
process.
No picture
Cause
The video source is not turned
on or connected correctly.
The projector is not correctly
connected to the input signal
device.
The input signal has not been
correctly selected.
Blurred image
Cause
The projection lens is not
correctly focused.
The projector and the screen are
not aligned properly.
74
Troubleshooting
Remedy
Plug the power cord into the AC inlet
on the projector, and plug the power
cord into the power outlet. If the power
outlet has a switch, make sure that it is
switched on.
Wait until the cooling down process has
completed.
Remedy
Turn the video source on and check that
the signal cable is connected correctly.
Check the connection.
Select the correct input signal with the
SOURCE key on the projector or
remote control.
Remedy
Adjust the focus of the lens using the
focus ring.
Adjust the projection angle and
direction as well as the height of the
unit if necessary.
Advertisement
Table of Contents
