Table of Contents
Advertisement
Replacing the lamp
• If lamp replacement is performed while the projector is suspended
upside-down from the ceiling, make sure that no one is underneath the
lamp socket to avoid any possible injury or damage to the human eyes
caused by fractured lamp.
• To reduce the risk of electrical shock, always turn the projector off and
disconnect the power cord before changing the lamp.
• To reduce the risk of severe burns, allow the projector to cool for at least
45 minutes before replacing the lamp.
• To reduce the risk of injuries to fingers and damage to internal
components, use caution when removing lamp glass that has shattered
into sharp pieces.
• To reduce the risk of injuries to fingers and/or compromising image
quality by touching the lens, do not touch the empty lamp compartment
when the lamp is removed.
• This lamp contains mercury. Consult your local hazardous waste
regulations to dispose of this lamp in a proper manner.
• To assure optimal performance from the projector, it is recommended
that you purchase a BenQ projector lamp for lamp replacement.
• Ensure good ventilation when handling broken lamps. We recommend
that you use respirators, safety glasses, goggles or face shield and wear
protective clothing such as gloves.
1.
Turn the power off and disconnect the projector from the wall socket. If
the lamp is hot, avoid burns by waiting for approximately 45 minutes
until the lamp has cooled.
2.
Loosen the screw from the right
side.
3.
Remove the lamp compartment
cover as shown.
Maintenance
69
Advertisement
Table of Contents
