Pin In Opc-Mode - Siemens SINAUT MD720-3 System Manual

SINAUT MD720-3 in OPC Mode
5.4

PIN in OPC-Mode

Enter the PIN
If the LED "S" blinks slowly (1 time per second), the SINAUT MD720-3 waits for a
PIN entry.
In OPC-Mode the PIN is sent by the connected PLC to the SINAUT MD720-3.
Therefore you need to enter the PIN in the data module of your SPS program with
reference to the program module WDC_INIT (See System manual SINAUT MICRO
SC). Please check if the PLC and the SINAUT MD720-3 are connected together.
The LED S (Status) blinks fast
If the LED S blinks fast (4 times per second), either the SIM card was not detected
or he SIM card is PUK-blocked, because a wrong PIN has been entered too often.
1. Please check, if the SIM card has been inserted correctly into the device (refer
to chapter 2 Inserting the SIM card).
2. Please check, if the SIM card is PUK-blocked. Insert the SIM card into a
common mobile phone. The mobile phone will display, if the SIM card is PUK-
blocked. If the SIM card is PUK-blocked, please enter the PUK and then a PIN.
You can use a common mobile phone to do this.
3. Before you enter again the SIM card into the SINAUT MD720-3, please
investigate why the SIM card has been PUK-blocked: Which PIN have you
entered into your PLC program?
4. Please check and eventually reset the parameter SIMSTATE of the SINAUT
MD720-3.
Check and reset the parameter SIMSTATE
The parameter SIMSTATE will be displayed when you press the SET button (refer
to 6.2 Getting the current settings and values):
SIMSTATE=SIM_OK
SIMSTATE=SIM_ERROR
SIMSTATE=SIM_PROBLEM
In case of SIMSTATE=SIM_ERROR or SIMSTATE=SIM_PROBLEM please
proceed as follows:
60
Ready for operation
Wrong PIN; one wrong PIN entry
Wrong PIN; two wrong PIN entries or no SIM
detected
SINAUT MD720-3
C79000-G8976-C211