Siemens SINAUT MD720-3 System Manual page 54

SINAUT MD720-3 in Terminal Mode
AT+CSMP Set SMS text mode parameters
Test
AT+CSMP=?
Command:
Response: +CSMP: (list of <fo>),(list of <vp>),(list of <pid>),(list of <dcs>)
OK
Read command
Command: AT+CSMP?
Response: +CSMP: <fo>,<vp>,<pid>,<dcs>
OK
Executive command
Command: AT+CSMP=[<fo>[,<vp>[,<pid>[,<dcs>]]]]
Response: OK
Parameter: <fo>
17
<vp>
Determines the period of time the SMS will be stored in the SMS Service Center:
0 to 143:
144 to 167
168 to 196
197 to 255
<pid>
0
<dcs>
0
Notice: Until firmware version 1.6 inclusive, only the <vp> values 71, 167, 173 and 255 have
been supported.
In the composite AT command AT+CMGF=1+CSMP=17,0,0,0+CSCA="
+AAAAAAAAAAA" the value 0 for <vp> will be accepted, but 0 will be replaced by the
value 71.
54
(<vp> + 1) * 5 minutes (e.g. 5 minutes interval up to 12 hours)
12 hours + (<vp> - 143) x 30 minutes
(<vp> - 166) x 1 day
(<vp> - 192) x 1 week
SINAUT MD720-3
C79000-G8976-C211