Connecting The Load; Connection Notes; Connecting The Load (Standard Model) - Kubota J106-STD Operator's Manual

16

CONNECTING THE LOAD

CONNECTING THE LOAD
MOKUJIYOU
BConnection Notes
To avoid personal injury:
A Before the
connected to a building's electrical
system, a licensed electrician must
install an isolation (transfer) switch
in the building's main fuse box. The
switch is the connection point for
generator power
selection of generator or main line
power to the building. This will
prevent the generator from charging
the main power line (backfeeding)
when the main power supply has
failed or has been turned off for line
repair. Backfeeding can electrocute
or injure line maintenance personnel.
Also, generator
electrical system damage can occur
when normal
returns if unit is used without an
isolation switch.
1. Avoid connecting the generator to commercial power
outlet.
2. Avoid connecting the generator in parallel with any
other generator.
BConnecting the Load (Standard Model)
To avoid personal injury:
A Connect or disconnect the load to
the AC receptacles or terminals only
when the engine is stopped.
A For your safety, close the terminal
cover after connecting the load.
A For your safety, secure the cover
with the lock bolts.
1. Turn OFF the circuit breaker on the control panel.
2. Connect the load to the A.C. output terminals.
3. Be sure to close the terminal cover after connecting
the load.
generator can be
and allows
and building
operating power
(1) Circuit breaker
(2) Terminals (output)
(3) Cover lock bolt
C Single phase 2 terminals type
i ) J106-STD, J108-STD, J112-STD, J116-STD
50Hz 220V
[Single phase]
(1) Light
(2) Television
(3) Air conditioner
(4) Electric drill
(5) Motor pump