Table of Contents
Advertisement
3. Ensure that the fuel lever is set to the
"OPEN" Position.
(1) Fuel lever
(2) Water separator
4. Insert the key into the main switch and
turn it "ON".
5. Check the battery charge lamp and oil
pressure lamp are "ON".
(1) Water temperature lamp
(2) Oil pressure lamp
(3) Battery charge lamp
(4) Glow timer lamp
A Do not use ether or any starting fluid for starting the
engine, or severe engine damage will occur.
A When there is a severe overload or short circuit in the
wiring of the generator, the circuit breaker turns OFF.
If this happens, eliminate the cause and then turn the
circuit breaker ON again.
(A) "OPEN"
OPERATING THE GENERATOR
6. Turn the key to "GLOW" position.
A See "Cold Weather Starting" section as to the
preheating times.
7. Turn the key to the "START" position
and release when the engine starts.
(1) Main switch (Key)
A Do not run the starter motor continuously for more
than 10 seconds at a time, or it may damage the
starter. If the engine fails to start, wait for about 30
seconds and try again.
8. Check to see that the battery charge
lamp, oil pressure lamp and water
temperature lamp are "OFF".
9. Check the warning lamps.
Whenever the engine stops automatically during
operation, correct the problem before restarting the
engine.
10. For 5 minutes after engine start-up, allow
engine to warm up without applying any
load.
A If load should be applied to the engine without this
warm-up period, trouble such as seizure, breakage or
premature wear may develop.
23
(A) "OFF"
(B) "ON"
(C) "GLOW"
(D) "START"
Hide quick links:
Advertisement
Table of Contents
