Installing/Removing Modules; Installing A Module - Siemens RUGGEDCOM RX1500 Installation Manual

Chapter 3
Communication Ports
For specifications, refer to
Section 3.9

Installing/Removing Modules

The following sections describe how to install and remove modules:
• Section 3.9.1, "Installing a Module"
• Section 3.9.2, "Removing a Module"
Section 3.9.1

Installing a Module

Upon installing a new module in the device, all the features associated to the module are available in the
operating system. For more information, refer to the ROX II User Guide for the RX1500.
To install a module, do the following:
1. Make sure power to the device has been disconnected and wait approximately two minutes for any
remaining energy to dissipate.
2. If the device is installed in a rack, remove it from the rack.
3. Remove the current module from the slot. For more information, refer to
4. Insert the new module into the slot.
1
2
3
Figure 51: Installing a Module
1. Module 2. Chassis
5. Tighten the screws to secure the module.
6. If necessary, install the device in the rack.
7. Connect power to the device.
30
Section 4.7, "RUGGEDCOM APE
3. Screw
Specifications".
Section 3.9.2, "Removing a
RUGGEDCOM RX1500
Installation Guide
Module".
Installing/Removing Modules