Mounting The Device On A Din Rail - Siemens RUGGEDCOM RX1500 Installation Manual

RUGGEDCOM RX1500
Installation Guide
Figure 2: Rack Mount Adapters
1. Rear 2. Front
2. If required, install adapters on the opposite side of the device to protect from vibrations.
3. Insert the device into the rack.
4. Secure the adapters to the rack using the supplied hardware.
Section 2.1.2

Mounting the Device on a DIN Rail

For DIN rail installations, the RX1500 can be equipped with panel/DIN rail adapters pre-installed on each side of
the chassis. The adapters allow the device to be slid onto a standard 35 mm (1.4 in) DIN rail.
To mount the device to a DIN rail, do the following:
1. Align the adapters with the DIN rails and slide the device into place.
Figure 3: DIN Rail Mounting
1. Panel/DIN Rail Adaptor
2. Install one of the supplied screws on either side of the device to secure the adapters to the DIN rails.
Mounting the Device on a DIN Rail
1
3
3. Rack Mount Adapter
2. DIN Rail 3. Screw
Installing the Device
2
3
1
2
3
Chapter 2
1
2
7