Connecting To A Customer-Supplied Dc Power Source - Nortel CVX 600 Hardware Installation Manual

Connecting to a Customer-Supplied DC Power Source

The customer-supplied DC power source is only for the DC chassis option.
Prerequisites
Before connecting the CVX 600 to a DC power source, see
Warnings"
296-1011-202 Rel. 5.0, Doc. Rev. 02.01
on page vii.
Caution: Ensure that the wire gauge you use is adequate for the distance
between the CVX 600 and the DC power source. Before connecting
power cables to the CVX 600, use a volt/ohm meter to ensure that the
power cables are not live.
Chassis Connections
Connecting Power to the Chassis
"DC Power Supply
2-21