32 Media Dependent Adapter installation for the 8672ATME and 8672ATMM modules
5
Connecting fiber cables
This procedure describes how to connect fiber cables to the installed
MDA. The OC-12c/STM-4 MDA uses duplex SC connectors. See
5 "OC-12c/STM-4 MDA duplex SC connector with dust caps" (page
Also, the OC-3c/STM-1 MDA uses MT-RJ connectors. See
"OC-3c MDA/STM-1 MT-RJ connector with dust cap" (page
Figure 5
OC-12c/STM-4 MDA duplex SC connector with dust caps
Figure 6
OC-3c MDA/STM-1 MT-RJ connector with dust cap
Procedure steps
Step
1
Installation — Media Dependent Adapters for the 8672ATME and 8672ATMM Modules
Copyright © 2008 Nortel Networks
.
If you do not plan to install a replacement MDA, place the slot
cover on the MDA slot and tighten the two screws.
Action
Remove the protective dust plug from the connector on the
installed MDA. Store the dust plug for later use.
Nortel Ethernet Routing Switch 8600
NN46205-316 01.01 Standard
30 May 2008
--End--
Figure 6
Figure
32).
32).