Nortel 8672ATMM Installation Manual page 29

3
4
5
6
Installation — Media Dependent Adapters for the 8672ATME and 8672ATMM Modules
Copyright © 2008 Nortel Networks
.
Line up the MDA with the front of the 8672ATME or the
8672ATMM module, positioning the MDA so that the front aligns
with the front of the 8672ATME or the 8672ATMM module.
Align the four holes on the MDA with the mounting posts on the
8672ATME or the 8672ATMM module.
Press firmly on the MDA in the middle of the back to seat the
MDA in the mounting posts on the module. Apply about 20
pounds of pressure.
When the MDA is seated properly, the posts of the module are
visible in the holes of the MDA.
Insert the Phillips pan head screws through the holes. Use a
#1 Phillips screwdriver to tighten the screws. Tighten the rear
screws first before you tighten the front screws.
Nortel Ethernet Routing Switch 8600
NN46205-316 01.01 Standard
30 May 2008
Installing an MDA 29